A: connecting rods
B: piston rods
C: tie rods
D: jack-bolt
举一反三
- The complete assembly of bedplate, A-frames and cylinder block is held together by () to form a rigid structure. A: tap-bolts B: jack-bolts C: tie rods D: fitted rod
- Block group contains______. A: connecting rods,crankshaft and flywheel B: pistons,connecting rods and oil pan C: cylinder block,cylinder head and oil pan D: piston rings,gasket and connecting rods
- A-frames and cylinder block is held together by _____ to form a rigid structure.
- Block group contains ________. A: connecting rods, crankshaft and flywheel B: pistons, connecting rods and oil pan C: cylinder block, cylinder head and oil pan
- The sealing rings are in four parts and pressed together around the piston rods by means of ().
内容
- 0
The gas loads on the engine structure are constrained by means of hydraulically preloaded () which connect the bed plate, frame sections and cylinder jackets into a single unit. A: connecting rods B: main bearing C: column D: tie rod
- 1
The gas loads on the engine structure are constrained by means of hydraulically preloaded () which connect the bed plate, frame sections and cylinder jackets into a single unit. A: Aconnecting rods B: Bmain bearing C: Ccolumn D: Dtie rods
- 2
Suppose that both the cross-sectional area A and the length L of two straight rods are the same, and the axial tension forces P at both ends of the two are also the same. Only the materials of the two rods are different. Which statement about the stress σ and the elongation ΔL of the two rods is right?__________
- 3
What are the key parts of the suspension system?( ) A: shock absorbers B: rods C: springs
- 4
() rods are not in proper condition so that too much fuel is supplied to the corresponding cylinder.