If a circular shaft is under torsion, then there should be only shear stresses and no normal stresses on its cross section.
A: 正确
B: 错误
A: 正确
B: 错误
举一反三
- When a shaft having a circular cross section is subjected to a torque, the cross section remains plane while radial lines rotate. This causes a ( ) within the material that varies ( ) along any ( ) line. A: shear strain; linearly; radial B: normal strain; linearly; radial C: shear strain; nonlinearly; radial D: shear strain; nonlinearly; longitudinal
- The general three-dimensional state of stress at a point can be represented by an element oriented so that only ( ) act on it. A: three principal stresses B: two principal stresses and one shear stress C: six principal stresses D: three absolute maximum shear stresses
- If the normal stress on the cross section of the axial tensile rod is σ, then the normal stress and shear stress on the 45° degrees section are .
- For a bar under axial tension, the sections with the maximum normal stress and maximum shear stress are A: the cross section and inclined section with inclined angle 45°, respectively. B: both the cross sections. C: the inclined section with inclined angle 45°and cross section, respectively. D: both the inclined sections with inclined angle 45°.
- In the fixedly combined circular shaft shown in the figure, the central part of the material is steel, shear modulus G1=80GPa, the outer material is copper and the shear modulus G2=39GPa. The distribution of shearing stress on cross section is___after torsional deformation. ① ② ③ ④http://image.zhihuishu.com/zhs/onlineexam/ueditor/201904/e48a2be70d9f4eec8d38b0270076b6e2.png