Given the following output：
A: The speed of the slowest interface in the port channel
B: The combined speed of all interfaces configured in the port channel
C: The combined speed of all interfaces in the port channel that are up
D: The speed that can be achieved if all buffers are used
A: The speed of the slowest interface in the port channel
B: The combined speed of all interfaces configured in the port channel
C: The combined speed of all interfaces in the port channel that are up
D: The speed that can be achieved if all buffers are used
举一反三
- Looking up all the new words in a dictionary can speed up your reading.
- 将Catalyst 6500交换机第2个模块的端口1～端口6数据传输速率设置为1000Mbps，正确配置语句是______。 A: Switch-PHY-6500(config)# interface g2/1-6Switch-PHY-6500(config-if)# set port speed 2 1-61000 B: Switch-PHY-6500(config-if)# duplex 3 1-8 full C: Switch-PHY-6500＞(enable) set port speed 2/1-61000 D: Switch-PHY-6500＞(enablel) set port speed 2 1-6 1000000000
- You are selecting a channel for sending your message. Which of the following is NOT a factor to consider when making this decision? A: Amount and speed of feedback and interactivity required B: Cost of the channel C: Confidentiality and sensitivity of the message D: Your competitors' channel use
- When underway in a channel，you should keep to the（）. A: Middle of the channel B: Starboard side of the channel C: Port side of the channel D: Side of the channel that has the widest tur
- Every vessel should at all times proceed at a safe speed. Safe speed is defined as that speed where ____.